To start IP tables on your RedHat server,
# service iptables start
You can run the following command to stop iptabes:
# service iptables stop
It is also important to save your iptables configuration so that it is loaded again on the next reboot. This can be done by running:
# service iptables save
You can also set the iptables program to start on boot by running:
# chkconfig iptables on
Categories
Categories
- 0 Users Found This Useful
Related Articles
Hardware Firewall configuration
A Hardware Firewall is a network device that is connected upstream from a server. The Firewall...
Ranges to allow through server firewall
Frontend (public) network:Ports to allow:ICMP – ping (for support troubleshooting)All...
Can I load balance servers that are behind a firewall?
Yes, in proxy mode your servers can live anywhere and as long as you can get to the real port you...
Using a hardware firewall/changing the secondary subnet to a secondary on the vlan
We currently do not offer these two services on the same public vlan. Your server will need to be...